What types of aggregate are used in concrete?

What types of aggregate are used in concrete?

The most commonly used aggregates—sand, gravel, crushed stone, and air-cooled blast-furnace slag—produce freshly mixed normal-weight concrete with a density (unit weight) of 2200 to 2400 kg/m3 (140 to 150 lb/ft3). Aggregates of expanded shale, clay, slate, and slag (Fig.

How many types of coarse aggregate are there?

Classification of Coarse Aggregate There are three kinds of rocks, namely, igneous, sedimentary and metamorphic. In such, many properties of aggregate depend on the properties of the parent rock itself. Coarse aggregates are classified into two main groups: (i) single-size aggregate and (ii) graded aggregate.

How deep should type 1 be?

100mm

What is the difference between scalpings and Type 1?

Please Note -Type 1 has a lower fines percentage than scalpings and therefore a greater load bearing capability. It is the recommended material for highly trafficked areas such as highways, car parks, footpaths, driveways and hard standings.

Can MOT Type 1 make concrete?

The proportion of fines in MOT Type 1 is far too high to make a decent concrete. There is no chance of coating all the particles with cement paste.

Can you lay MOT Type 1 in the rain?

Yes it will be fine, compact it in 50mm layers wetting it before compacting, it will goes as hard as concrete.

How do you compact a sub base without a compactor?

A traditional garden roller is great for compacting a sub-base. Garden rollers are generally filled with sand or water to give them weight (100kg is suggested) and then rolled backwards and forwards across the sub-base material to compact it. This method should result in a very smooth and even surface.

Can you screed wet sand?

Rain stops play - damp sand won't brush! Blacktop (tarmacadam) and asphalt can be laid during light precipitation, but should not be laid over areas of standing water. ... For unbound laying courses, the usual rule of thumb is that the bed or screed should not be saturated or hold excess water.

What causes pavers to sink?

Pavers can sink for many reasons, however. A couple of common ones are lack of water drainage and having too much bedding sand. We will have to pull up the paving stones, remove our bedding layer, add gravel, tamper the gravel, and put some new sand back in—then we can lay our pavers again.