Which end is up on crown molding?

Which end is up on crown molding?

Crown molding can look good both ways: in its usual alignment or upside-down, which makes it difficult to determine the end that's supposed to be the top. Generally, the end with the least amount of detail goes on top, and the decorative trim faces the bottom.

What angle should crown molding be cut at?

45 degrees

Does crown molding have to be nailed into studs?

Crown moldings, or any corner trims really should be nailed to a stud, not simply into unbacked drywall. Without good support, the molding will warp out from the wall causing gaps in coverage to open along the edges. ... This gap results in having to use longer nails to reach the wall and support wood behind the sheetrock.

Can I use brad nails for crown molding?

Crown is typically nailed up with a 2” finishing nail and a compressor and finishing gun. Outside corners are usually done with a brad nailer and 1” brad nails with glue. ... For 3” rise or less crown moulding you won't need to mark out the studs, as you will nail into the top plates.

Does crown molding look good in small rooms?

Crown molding does not make a room look smaller — in most instances. Whether it does or does not depends largely upon how high your ceilings are and how wide the molding is. If the room is small and has normal or low ceilings, a 2- to 4-inch-width molding is appropriate.

How do you paint interior trim without brush marks?

3 Tips and Tricks for Painting without brush strokes Go with the grain. In any painting project, trim included, paint with the grain of your wood rather than across it. This ensures the smoothest finish. Cut in first, and then paint the middle.

Can you paint wood crown molding?

For the best finish, crown should be painted after installation, not before. Sure, it's easier to prime and paint before install, but you still have to caulk the molding to the drywall and patch all of the nail holes, which means touch-ups, and touch-ups in the middle of semi-gloss paint leave blemishes in the finish.