How do you remove molding from a fireplace?

How do you remove molding from a fireplace?

Pound the bottom of the mantel shelf with a rubber mallet to separate it from the wall if it doesn't release when you pry the base of the mantel away from the wall. Tap it gently, but with enough force to pull the nails from the wall. Once it's loosened, pull out on the shelf to remove it.

How are fireplace surrounds attached?

Fireplace surrounds are typically hollow structures (as shown below) and so can be attached to the wall with metal brackets located at the edges of the surround, or even screwed onto another piece of wood that's already joined to the wall.

How do you attach a floating mantel to a brick fireplace?

How to Install a Mantel

1. Remove the old mantel.
2. Add support by drilling holes for lag shields, then install lag bolts into the brick.
3. Measure carefully and drill corresponding holes for the wood mantel.
4. Push the wooden mantel carefully into place using wood glue for extra support.

How do you remove a brick fireplace?

Place the blade of the chisel on the mortar between the bricks and tap the end of the handle with a hammer. Continue hitting the chisel until you remove as much mortar as you can. Once all of the mortar around the brick is loose, the brick will easily come off your chimney.

Can you knock out a fireplace?

Break out a plasterboard sheet, using a club hammer, or use a padsaw or jigsaw to cut around the edge of a timber board. Unscrew or lever off any supporting battens. If the fireplace has been filled in with bricks, start from the vent and slowly knock out a few at a time with a club hammer and bolster chisel.

Can you take brick off a fireplace?

A: Yes, you can remove the brick facade and replace it with another material. And you will still be able to use the fireplace. The only restriction is that the material around the firebox must be noncombustible. Common choices are marble, some other type of stone or tile.

What is under a brick fireplace?

Foundation. Made of heavy-duty brick or cinder block, the foundation provides the structural support for the chimney's walls. Footing. Typically made of concrete, the footing is the surface under the ash pit in older homes or the firebox in homes without an ash pit.

What is behind the brick on a fireplace?

The brick you see on the fireplace is a facade. It is attached to the firebox by mortar. You'll be able to clean up the brick behind the facade and cover them with a new flat mortar bed to install the tile or marble. ... The mortar base will provide a good substrate to set your tile.

How expensive is it to remove a fireplace?

Unfortunately, taking out a brick fireplace and chimney, especially on a potentially load-bearing wall, is no small task. You're looking at a minimum of $10,000 for that kind of work. It'll be a big task, involving at least a couple of dumpster loads of waste and a week or more of work in your house.

Does a gas fireplace need a chimney?

Many ventless options may not require a chimney to exhaust the byproducts of combustion but some gas log sets still use and may require an existing chimney to dissipate the heat generated by burning. ... Most gas log sets require that they be installed into a properly maintained and code compliant chimney system.

What's the purpose of a chimney?

The chimney's function and significance for the stove. The primary function of the chimney is to direct the smoke away from the stove and out of the house. However, this is not the only function of the stove, as it must also: Ensure that enough air is drawn into the stove for the fire to burn clean.

What does a flue do on a fireplace?

Understanding Flues A flue is simply a passage for conveying exhaust gases from an appliance to the outdoors. A flue may be a duct, pipe, vent, or chimney. An unlined chimney is technically a flue, even though an unlined chimney is a fire hazard.

Why is rain coming in my fireplace?

One of the most common reasons for rain to leak into a chimney is physical damage or wear and tear to the chimney. ... Once small cracks form in the chimney's structure, water can easily seep into these spots. During cooler weather.