How do you measure a toilet setback?

How do you measure a toilet setback?

Measure from the wall behind the toilet to the center of one of the closet bolts (which hold the toilet down). If the toilet has four closet bolts, measure to the center of one of the rear ones. Then measure from the center of the mounting holes to the back of the new toilet you're considering.

How far can I move a toilet?

One thing you must know when moving your toilet is how far it must be away from the stack. In short, your toilet must be no more than 6-feet away from the stack if the waste line diameter is 3-inches. If the waste line diameter is 4-inches, the toilet must be no more than 10-feet away from the stack.

Can I move a toilet myself?

Moving a toilet is not a straightforward weekend DIY job, but it is very doable when you involve the professionals. Once the toilet itself is removed, your plumber will have to move the drainage, as well as the water supply to accommodate the new location.

How easy is it to swap a toilet and sink?

The easiest are little bolts that you unscrew so that the sink can be pulled up. In any case remove the old sink and clean up the counter around the hole. Put a new wax ring around the toilet base and drop the fixture into place. line up the flange bolts and tighten the toilet to the floor.

Is it possible to move a shower?

When moving a shower, you'll also need to install the shower head in the new location. You can either have your current shower head reinstalled or choose a brand new one. If you have an older showerhead, switching to a new one during this renovation is typically a better option.

How much does it cost to put a shower in?

According to bathroom remodeling data available online, the national average cost for installing a new shower is $4,130 (per HomeAdvisor). However, shower remodels can run as low as $300 for an economical option such as a premade kit, to $15,000 for a luxury walk-in, soaker tub combo.

Are all toilets the same size?

Most toilets will have a 12 inch rough-in. ... If you're replacing an existing toilet, look for a replacement toilet with the same rough-in. A toilet with a larger rough-in measurement will require you to change your plumbing configuration or move the wall to get the toilet to fit.

What do I need to install toilet?

Required Materials for this how to change a toilet Project

  1. Brass toilet bolts.
  2. Caulk.
  3. Flexible water supply.
  4. Plastic shims.
  5. Toilet flange.
  6. Wax ring.